topic Re: Handle /n end transaction command in program in Application Development and Automation Discussions

Handle /n end transaction command in program

Former Member — Tue, 24 Jul 2007 17:09:40 GMT

Is there a way to handle the end transaction command /n (start new transaction XXXX with /nXXXX) in a program?

I tested to use the sy-ucomm (i.e. ok_code), but it gets no value. Instead the program terminates immediately. This is not a good behavior. I need to free resources, terminate sessions and stuff.

Is there at least an event like PAI that I can use for that?

Any help would be much appreciated.

Regards Kilian

Re: Handle /n end transaction command in program

Former Member — Tue, 24 Jul 2007 18:08:17 GMT

Hi,

AFAIK there is no such way - "/n" ends your program without warning.

Regards, Joerg

Re: Handle /n end transaction command in program

marcelo_ramos1 — Tue, 24 Jul 2007 18:32:33 GMT

Hi,

I think there is not way to do this.

You can't adapt the programa to use Call transaction ?

Regards.

Marcelo Ramos