topic Re: bdc in Application Development and Automation Discussions

bdc

Former Member — Sat, 28 Jul 2007 09:15:50 GMT

experts i have written a bdc program(va02) .in that progarm the first screen is displayed then the second screen but on third screen the values r not coming i have debuged the program the values r coming in itab but when i run va02 transaction the values r not cming

.should i do the recording once more?

Re: bdc

Former Member — Sat, 28 Jul 2007 09:42:02 GMT

Check the entried in internal table BDC_TAB where u have append the values for ProgName and Screen if it is correct. and check the screen and prog name for 3rd screen of the transaction by going SYSTEM-> STATUS.

If it doesn;t work then do re-recording..

Regards

Prax

Re: bdc

Former Member — Sat, 28 Jul 2007 09:44:54 GMT

it shows that the recording was not done properly with the correct sequence of the screens

No values are coming into that screen means you have missed that screen sequence and that was not populated in the program

first you do a single transaction in VA02 and note down the screen sequence and field sequence then once again record the BDC and prepare the program and run the BDc and see

<b>Reward points for useful Answers</b>

Regards

Anji

Re: bdc

Former Member — Sat, 28 Jul 2007 15:20:14 GMT

hi,

while calling the transcation, use mode A.

example: call transcation VT02n mode ' A' using gt_bdcdata.

Regards,

Niyaz