topic Re: Idoc in Application Development and Automation Discussions

Idoc

Former Member — Wed, 01 Aug 2007 05:00:43 GMT

Hello,

I have a problem while posting the Idoc. Whe I post the Idoc, it showed status as 03 in transaction WE02. But it doesn't reaches to the destination.

When I run the program RBDMOIND it showed that the idocs are in queue.

I have configured the setting as Send Idoc immediately in both Partner Profile (WE20) and Distribution model (BD64).

I have tried to use the transaction WE14 but then also it doesn't works.

Can you please help me to solve the problem?

Thanks & Regards.

Abhijit

Re: Idoc

Former Member — Thu, 02 Aug 2007 14:56:28 GMT

Go to SM58 transaction.

-->if you find your entries.

~~>Select one and press F6 or from menu select EDIT~~>Execute LUW.

Click refresh

If you see red marked then its problem in destination, if select one is disapper now you will idoc in destination.

Normally this should not happen, if same thing happen check OSS notes.

"Reward point if usefull".

Thanks,

Narayan

Re: Idoc

Former Member — Tue, 21 Aug 2007 05:33:12 GMT

Hello Narayan,

Thanks for the input. Whatever you told that worked. Even in the program RBDMOIND it showed that the selected messages have been dispatched.

But, I am not able to see the idoc at the destination.

Can you please help me in that matter?

Thanks & Regards.

Abhijit.

Re: Idoc

Former Member — Wed, 22 Aug 2007 03:23:18 GMT

Again did you checked SM58 transaction.If it is there then you have apply OSS notes. Actually we also had a same problem then basis team applied OSS but not sure OSS note number.

Thanks,

Narayan

Re: Idoc

varma_narayana — Wed, 22 Aug 2007 04:29:53 GMT

Hi..Abhijit..

There may be problem with The RFC Destination if the IDOCS are not despathed successfully to the Target sys.

So Goto SM59 and Open the RFC destination.

Then perform the TEST CONNECTION and REMOTE LOGIN.

(You can ask your Basis Admin if u dont have authorizations)

This may help you....

<b>Reward if Helpful.</b>

Re: Idoc

Former Member — Tue, 28 Aug 2007 09:41:05 GMT

Hello Narayan,

Thanks for the help.

I have tested the RFC destination both the Connection Test and Remote Logon. Those two buttons are working properly. I am able to get to the target system through those two buttons.

But still in the transaction I am able to see that the system have executed the LUW but then also, i am not able to see at the target destination.

Please regarding that matter.

Thanks.

Abhijit