topic Re: user interaction in Application Development and Automation Discussions

user interaction

Former Member — Mon, 30 Jul 2007 12:16:08 GMT

Hi!

A current internal table has some values (Tranportation Nr.) The requirement

is now to give any user a possiblibilty via dialog to do the following:

1.) show him which Tranportation Nr. are available (depending

on internal table's content. Filling dynamically)

2.) to give him the possiblity to select single Tranportation Nr or a range

Regards

Ilhan

Re: user interaction

Former Member — Mon, 30 Jul 2007 12:24:34 GMT

Hi IIhan,

use table control in dialog programing to show the selcted value from int table.

u can switch on multiple selected lines to give user the flexibility to select multiple lines on screen.

Regards

Krishnendu

Re: user interaction

Former Member — Mon, 30 Jul 2007 12:27:04 GMT

hello,

thank you for this hint do youe have an example or a sniplet

for a such small requirement ?

reagards

ilhan

Re: user interaction

Former Member — Mon, 30 Jul 2007 12:32:52 GMT

Hi,

see this example.

it will get the purchasing orders corresponding the the vendor numbers u entered in the first screen

PROGRAM ZBHTCTRL.

TABLES: LFA1, EKKO.

DATA: OKCODE1 LIKE SY-UCOMM,

OKCODE2 LIKE SY-UCOMM.

CONTROLS TABC TYPE TABLEVIEW USING SCREEN 1001.

DATA: BEGIN OF ITAB OCCURS 0,

MANDT LIKE EKKO-MANDT,

EBELN LIKE EKKO-EBELN,

BSTYP LIKE EKKO-BSTYP,

BSART LIKE EKKO-BSART,

END OF ITAB.

MODULE USER_COMMAND_1000 INPUT.

CASE OKCODE1.

WHEN 'BACK'.

SET SCREEN 0.

WHEN 'NEXT'.

SET SCREEN 1001.

SELECT * FROM EKKO INTO CORRESPONDING FIELDS OF TABLE ITAB WHERE

LIFNR = LFA1-LIFNR.

ENDCASE.

ENDMODULE. " USER_COMMAND_1001 INPUT

MODULE MOVE_DATA OUTPUT.

EKKO-MANDT = ITAB-MANDT.

EKKO-EBELN = ITAB-EBELN.

EKKO-BSTYP = ITAB-BSTYP.

EKKO-BSART = ITAB-BSART.

ENDMODULE. " MOVE_DATA OUTPUT

MODULE USER_COMMAND_1001 INPUT.

CASE OKCODE2.

WHEN 'BACK'.

SET SCREEN 1000.

ENDCASE.

ENDMODULE. " USER_COMMAND_1001 OUTPUT

MODULE STATUS_1001 OUTPUT.

SET PF-STATUS 'MENU'.

SET TITLEBAR 'TIT'.

ENDMODULE. " STATUS_1001 OUTPUT

MODULE STATUS_1000 OUTPUT.

SET PF-STATUS 'DMENU'.

SET TITLEBAR 'xxx'.

ENDMODULE. " STATUS_1000 OUTPUT

reward if helpful

rgds,

bharat.

Re: user interaction

Vijay — Mon, 30 Jul 2007 12:33:46 GMT

hi llhan

just refer to the link below

http://www.sapmaterial.com/tablecontrol_sap.html

step by step procedure with screen shots

regards

vijay

plz dont forget to reward points if helpful