topic Re: Reg : debugging in Application Development and Automation Discussions

Reg : debugging

Former Member — Mon, 06 Aug 2007 12:00:05 GMT

Hi Frnds ,

Im having doubt in Debugging wit the following code .

loop at tl_objects.

tl_ebeln-ebeln = tl_objects-objectid.

append tl_ebeln.

endloop.

Here the tl_objects internal table having 3000 entries .

when i try 2 debug, because of loop i need to press f5 for 3000 times .

is der any shortcut to come out of the loop without checking the entire internal table values ..

Regs ,

Narayana

Re: Reg : debugging

seshatalpasai_madala — Mon, 06 Aug 2007 12:01:41 GMT

HI,

Just double click on the statement next to ENDLOOP to place a Break point.

Then press F8 to stop at this break point. By this you have come out of the LOOP and also to the next statement after the loop.

Or put a break point in SE38 in the statement after ENDLOOP and then when you are in LOOP press F8 to navigate to this statement where you have set the break point.

Regards,

Sesh

Re: Reg : debugging

Former Member — Mon, 06 Aug 2007 12:02:56 GMT

Hi,

Put a break point after the loop and press F8 when it came to the loop.

Regards

Kannaiah

Re: Reg : debugging

Former Member — Mon, 06 Aug 2007 12:04:30 GMT

just click the double click on the endloop so the break point will set to the next ststement

and then press F8 so the next statement after the loop will executed and from then you can use F5

reward me if usefull

Re: Reg : debugging

Former Member — Mon, 06 Aug 2007 12:04:49 GMT

Hi,

Place a break point after the endloop statement and while executing press F8.

It will come to the next break point.

Regards

Arun

Re: Reg : debugging

Former Member — Mon, 06 Aug 2007 12:04:52 GMT

use F6 instead of F5....

or else give BREAK-point statement outside the loop.

Loop at itab.

....

endloop.

BREAK-POINT...

and give F8 when the cursor comes to the Loop statement.

Re: Reg : debugging

Former Member — Mon, 06 Aug 2007 12:05:44 GMT

Hi,

place ur cursor at the statement after endloop.

and press F8.(shortcut key for running the program up to cursor)

rgds,

bharat.

Re: Reg : debugging

Former Member — Mon, 06 Aug 2007 12:11:06 GMT

place a break point after the endloop statement ...and execute. it will go to debugging only after the loop. if u want to check statements prior to the loop staements.place breakpoints whereever u want and click on run

reward if useful.