topic Re: call transaction without pressing execute button in Application Development and Automation Discussions

call transaction without pressing execute button

Former Member — Tue, 07 Aug 2007 17:36:38 GMT

Hi,

When I enter a value in a field and click on a push button call transaction works fine the first time. When I enter different value in the field and click on it again call transaction works but says No changes made.

But if I click on the execute button and click on the push button again, it works fine.

When i ran it in mode A, the below code didnt work during the second time.

*perform screen using: 'SAPLQPLS' '0100'.

*perform field using: 'BDC_CURSOR' 'RMQAM-AKTIV(01)',

*'RMQAM-AKTIV(01)' 'X',

*'BDC_OKCODE' '=WEIT'.

Regards,

bindazme

Re: call transaction without pressing execute button

Former Member — Tue, 07 Aug 2007 19:11:52 GMT

Are you clearing your BDC internal table?

Re: call transaction without pressing execute button

Former Member — Tue, 07 Aug 2007 20:43:07 GMT

Try to check events. Write your BDC CODE in AT SELECTION SCREEN

Re: call transaction without pressing execute button

Former Member — Tue, 07 Aug 2007 21:06:10 GMT

There will be several reasons :

1. if you are not clearing BDC Internal table..

call transaction 'TCODE' using BDCDATA

MODE 'A'.

refresh bdcdata. -> this is mandatory after call transaction.

2. would be data updation,some times it updates transaction level,not in DB Level.

so use update mode as "S'.

call transaction 'TCODE' using BDCDATA

MODE 'A'

UPDATE 'S'.

Thanks

Seshu

Re: call transaction without pressing execute button

Former Member — Wed, 08 Aug 2007 05:33:50 GMT

Thanks, actually i was not refreshing the bdcdata.

bindazme