topic Re: hou to use bage break in table using smartforms in Application Development and Automation Discussions

hou to use bage break in table using smartforms

Former Member — Mon, 25 Jun 2007 10:23:25 GMT

hi friends,

<b>hou to use bage break in table using smartforms</b>

Re: hou to use bage break in table using smartforms

Former Member — Mon, 25 Jun 2007 10:28:21 GMT

hi,

use variable &sysf-formpage&.

Use SFSY-FORMPAGES to display the total number of pages in the Smartforms

&SFSY-PAGE& Current page number

&SFSY-FORMPAGE& Total number of pages in the currently formatted layout set

&SFSY-JOBPAGE& Total number of pages in the currently formatted print request

&SFSY-COPYCOUNT& Original-1,1st copy-2

&SFSY-DATE& Date

&SFSY-TIME& Time

&SFSY-USERNAME& Username

reward points if useful,

regards,

seshu.

Re: hou to use bage break in table using smartforms

Former Member — Mon, 25 Jun 2007 10:30:05 GMT

to get page braek in smartforms

u shud specify<b> sy-tabix not equal to 1 in the command lines created</b> in ur window of the smartform.

Hope this helps.

****Reward points if helpful.

Re: hou to use bage break in table using smartforms

Former Member — Mon, 25 Jun 2007 10:30:22 GMT

It depends upon requirment put some condition in any window and it will trigger based on the condition

Regards

Shiva

Re: hou to use bage break in table using smartforms

Former Member — Mon, 25 Jun 2007 10:47:51 GMT

Dear Raj

Insert Command after table line and in command write condition like mctr = 10 etc as per your requirement. it will jump to next page when counter will reach to 10.

Regards

Rajiv Singh.

Re: hou to use bage break in table using smartforms

Former Member — Mon, 25 Jun 2007 10:50:49 GMT

good

go through this link

http://myweb.dal.ca/hchinni/sap/smartforms/SmartForms.doc

thanks

mrutyun^

Re: hou to use bage break in table using smartforms

Former Member — Mon, 25 Jun 2007 10:56:01 GMT

Hi,

Use

NEW PAGE

in the code window to start new page in smart forms.

Thanks and Regards,

Kunjal Patel