topic Re: Changing SY-TCODE in Application Development and Automation Discussions

Changing SY-TCODE

Former Member — Thu, 28 Jun 2007 15:12:05 GMT

Hi All,

Is there any way to change the SY-TCODE Programatically.

Thanks,

Preethi.

Former Member — Thu, 28 Jun 2007 15:15:06 GMT

No! I don't think because the system would assign the value of the current transaction after changing it.

What do you need to do?

Max

seshatalpasai_madala — Thu, 28 Jun 2007 15:15:36 GMT

Hi,

We cannot change the SY-TCODE, this stores the current transaction code.

It has no effect even if you assign some thing to it.

But if you want to move to or call another transaction then use CALL TRANSACTION.

Regards,

Sesh

Former Member — Thu, 28 Jun 2007 15:16:04 GMT

well programatically...don know what you mean, but you can change it in the Debugger at any desired stage.

In the program if you populate the value at some stage ot may get over written by the system.

Former Member — Thu, 28 Jun 2007 15:16:46 GMT

I'm not sure I'd do this, but you can:

sy-tcode = 'XXX'.

I tested it. It retains the value. But I don't think it's good programming practice.

Rob

Message was edited by:

Rob Burbank