topic Re: VA01 USER EXIT PROBLEM in Application Development and Automation Discussions

VA01 USER EXIT PROBLEM

Former Member — Wed, 27 Jun 2007 07:06:31 GMT

When I used the EXIT in PRG ‘MV45AFZZ ’，

FORM USEREXIT_SAVE_DOCUMENT，

“READ TABLE XVBKD WITH KEY "VBELN = YVBAK-VBELN

POSNR = '000000'.

IF SY-SUBRC = 0 AND XVBKD-IHREZ IS INITIAL.

MESSAGE ID 'ZSDBCD' TYPE 'E' NUMBER '014' .

EXIT.

ENDIF.”

if the condition is ringht ,the display the message,but can not jump form the form,so display the message always,what can i do?

Re: VA01 USER EXIT PROBLEM

Former Member — Wed, 27 Jun 2007 07:36:19 GMT

Hi,

Remove EXIT statement.

Hope this helps you. Reply for queries, shall post the updates.

Regards.

Kumar.

Re: VA01 USER EXIT PROBLEM

Former Member — Wed, 27 Jun 2007 08:54:13 GMT

it did not work use the method.

Re: VA01 USER EXIT PROBLEM

Former Member — Wed, 27 Jun 2007 11:46:03 GMT

Hi,

Try doing like this:

FORM USEREXIT_SAVE_DOCUMENT，

“READ TABLE XVBKD WITH KEY "VBELN = YVBAK-VBELN

POSNR = '000000'.

IF SY-SUBRC <> 0 AND NOT XVBKD-IHREZ IS INITIAL.

EXIT.

ELSE.

MESSAGE ID 'ZSDBCD' TYPE 'E' NUMBER '014' .

ENDIF.”

Hope this helps!!!

Regards,

Krithiga.

Re: VA01 USER EXIT PROBLEM

seshatalpasai_madala — Wed, 27 Jun 2007 11:51:37 GMT

Hi,

When you raise an error message the control will not goto the next statement after the Error message.

So if you want to exit and still want the message to appear your message type 'S'.

READ TABLE XVBKD WITH KEY "VBELN = YVBAK-VBELN

POSNR = '000000'.

IF SY-SUBRC = 0 AND XVBKD-IHREZ IS INITIAL.

MESSAGE S014(ZSDBCD).

EXIT.

ENDIF

Regards,

Sesh

Re: VA01 USER EXIT PROBLEM

Former Member — Wed, 27 Jun 2007 11:54:59 GMT

Hi,

You may use FORM USEREXIT_SAVE_DOCUMENT_PREPARE instead of FORM USEREXIT_SAVE_DOCUMENT if possible.

Regards

Raju Chitale

Re: VA01 USER EXIT PROBLEM

Former Member — Thu, 28 Jun 2007 03:47:10 GMT

Some condition must judge by item ,and use Save_prepare ,the same not work