topic Re: Problem with table control in Application Development and Automation Discussions

Problem with table control

Former Member — Tue, 26 Jun 2007 22:54:11 GMT

Hi,

I have created one table control, to take the input. When i designed the TC i designed only for 5 lines, but unfortunately even on the screen it was comming like that only, i mean it was not dynamically extending...and did not see the vertical scroll bar...

Any one can help me...

regards

jaya

Re: Problem with table control

Former Member — Tue, 26 Jun 2007 23:01:59 GMT

Hi Jaya,

Refer to the below thread

Reward points if useful.

Regards,

Atish

Re: Problem with table control

gopi_narendra — Wed, 27 Jun 2007 02:08:49 GMT

in the PBO of the screen module, before calling the table control lines just write these statements

itab is the internal table being passed to the table control

tabctrl is the name of the table control placed on the screen.

data : N type I.
describe table itab lines N.
tabctrl-lines = N.

Regards

Gopi

Re: Problem with table control

jayanthi_jayaraman — Wed, 27 Jun 2007 02:33:29 GMT

Hi,

You need to increase the no. of lines in table control by adding some number other than exisitng.

For example,if your internal table is having 5 lines,then in table control make the no. of lines as 105 so that you can see the vertical scroll bar.

DESCRIBE TABLE lt_trans LINES fill.

tabctrl1-lines = fill + 100.

Check this link.In this, if you see the coding part, I am doing like that.

https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/com.sap.km.cm.docs/documents/a1-8-4/table%20control%20in%20abap.pdf

Message was edited by:

Jayanthi Jayaraman