topic Re: Background job in Application Development and Automation Discussions

Background job

Former Member — Tue, 05 Jun 2007 19:48:38 GMT

Hi,

I have defined a job in SM36 and i can see the status in SM37. But i have created couple of jobs with the same name ZTEST the parameters are different each time with different timings. each is a periodic job. Which one of these is valid? or all of them will run? I am not sure how to edit a scheduled job, delete a scheduled job. If i delete a job in SM37 is it as good as deleting it permanently?

Where can i see the list of jobs scheduled apart from SM37?

Also i wonder why am i not able to see the spool for this job. When i scheduled this job earlier with out a periodidc job i could see the spool.

Please answer these questions.

Thanks.

Re: Background job

Former Member — Tue, 05 Jun 2007 19:56:13 GMT

Hi,

You can delete the background JOb from Sm36 , if you want to see all the background Jobs, look at the table TBTCO give your Job name then you will get all the paramters and the status of the Job

Regards

Sudheer

Re: Background job

Former Member — Tue, 05 Jun 2007 19:58:31 GMT

I see 4 jobs defiend with the same name and differnt job count in the table. i want to delete all of them. how should i delete from sm36?

Re: Background job

Former Member — Tue, 05 Jun 2007 20:03:03 GMT

Hi,

You can Delete the job from Sm37, but it will delete the completed job, if you want to delete it permanently then use the report RSBTCDEL or RSBPSTDE

Regards

Sudheer

Re: Background job

Former Member — Tue, 05 Jun 2007 20:15:36 GMT

are all the parameters in the report RSBTCDEL mandatory. i gave jobname, user,start from and i get a msg no jobs found but in the table i see 2 jobs.

Where can i give the spool name when i am defining the job in SM36

Re: Background job

Former Member — Tue, 05 Jun 2007 23:14:42 GMT

Hi Vinni,

Just give Job Name, User and Status of the job (Scheduled, released, etc).

Reward points if useful.

Regards,

Atish

Re: Background job

Former Member — Wed, 06 Jun 2007 15:34:01 GMT

I did that but its not recognizing. Anyways thanks for the prompt response. I have used the FM BP_JOB_delete which was much easier.

Thanks again.

Re: Background job

Former Member — Wed, 06 Jun 2007 15:39:34 GMT

Got solution by myself