topic Re: BAPI or Function Module available to change the material type in Application Development and Automation Discussions

BAPI or Function Module available to change the material type

Former Member — Mon, 11 Jun 2007 14:06:52 GMT

Hi all,

Is there any BAPI or Function Module available to change the material type i.e T -code MMAM -I am on 4.6 C

Thanks

Re: BAPI or Function Module available to change the material type

Former Member — Mon, 11 Jun 2007 14:09:30 GMT

I guess no BAPI ,need to have bdc program

Re: BAPI or Function Module available to change the material type

Former Member — Mon, 11 Jun 2007 14:11:55 GMT

Check this : BAPI_MATERIAL_EDIT

Reward points if useful.

Shweta

Re: BAPI or Function Module available to change the material type

RichHeilman — Mon, 11 Jun 2007 14:22:40 GMT

There are BAPIs to change a material such as BAPI_MATERIAL_SAVEDATA, but I doubt very much that it will allow you to change the materail type, because the material type drives the actual number range that the materail was created in. Also, you may notice that it is not possible to change material type of a material via MM02.

Regards,

RIch HEilman

Re: BAPI or Function Module available to change the material type

Former Member — Mon, 11 Jun 2007 15:23:26 GMT

Hi Rich,

You mean to say there is no BAPI or FM available to change to material type.

So the only option is to go fro BDC

Let me know if i am wrong

Thanks

Preeti

Re: BAPI or Function Module available to change the material type

ferry_lianto — Mon, 11 Jun 2007 15:26:40 GMT

Hi,

Please use BDC to update material type as Seshu suggested earlier.

The transaction MMAM is not only updating material type but also other such document changes (CDHDR and CDPOS).

Regards,

Ferry Lianto

Re: BAPI or Function Module available to change the material type

Former Member — Mon, 11 Jun 2007 15:51:13 GMT

I tried to use BAPI Function module in one of my req ,but no luck

then I used BDC

Re: BAPI or Function Module available to change the material type

Former Member — Wed, 04 Jul 2007 11:58:06 GMT

Hi all,

I'm using BDC to perform mass change to MMAM.

Is there a way to capture the output log in MMAM?

Please advice...

Thanks.

Re: BAPI or Function Module available to change the material type

Former Member — Wed, 14 Nov 2007 11:09:05 GMT

If you have solution of it please send us. We are also facing similar problem.