How to type printer scape characters??

Former Member — Fri, 25 May 2007 07:27:18 GMT

Hi,

I have gone into SPAD - Device types - formats (inside my device type) - inside my format, i've gone to one action created by us: Printer initialization.

Here is where i can enter my printer control commands.

I have one: My printer manual says Ec&l12E to enter 12 lines at the upper border of my page. In SAP it is written \e&l12E. I supose this is the way we must write it, but it doesn't works.

Is \e the way to type Ec into SAP?

I'm trying to go down my output because it's displaced on tray 1 (110mm x 220mm),

Any suggestions??

Re: How to type printer scape characters??

Former Member — Sat, 26 May 2007 05:37:42 GMT

Hi,

One workaround is to increase the TOP MARGIN in SMARTFORM/LAYOUT.

Best regards,

Prashant

topic Re: How to type printer scape characters?? in Application Development and Automation Discussions

How to type printer scape characters??

Re: How to type printer scape characters??