topic Re: BAdi - LEDSP_SPLIT_EXECUTE in Application Development and Automation Discussions

BAdi - LEDSP_SPLIT_EXECUTE

Former Member — Sun, 27 May 2007 13:28:31 GMT

Hi All,

I have a requirment to do delivery split in TCode VLSP through BAdi LEDSP_SPLIT_EXECUTE .

Could anybody tell me how to use this BAdi ?

Thanks,

Re: BAdi - LEDSP_SPLIT_EXECUTE

Former Member — Fri, 01 Jun 2007 11:20:33 GMT

I need to add Loading Group as a criteria to do delivery split in Tcode VLSP. Could anyone tell me is there any process other then using the BAdi ?

Thanks,

Re: BAdi - LEDSP_SPLIT_EXECUTE

Former Member — Fri, 01 Jun 2007 11:30:38 GMT

Hi,

In BAdi - LEDSP_SPLIT_EXECUTE under interface tab click on the EXCUTE method under this Method EXCUTE Find the appropriate parameter.Then implement the BADI from SE19.

Regards

Re: BAdi - LEDSP_SPLIT_EXECUTE

Former Member — Fri, 01 Jun 2007 11:31:55 GMT

Hi,

there is no other way other than a BADI, coz i too worked on deleivry split , but its an outbound delivery VL01n and the BADI which i used is LE_SHP_DELIVERY_PROC.

How to triggerthis badi?

Go to Tcode SE19

give implementation name : ydel

then give definition name : LEDSP_SPLIT_EXECUTE

give short text

and ACtivate.

select INTERFACE tab

Doublie click on themethod EXECUTE

Now u can cod eur logic between METHOD and ENDMETHOD.

Revert back if anyissues.

Reward with Points if helpful.

Regards,

Naveen

Message was edited by:

Naveen Deva

Re: BAdi - LEDSP_SPLIT_EXECUTE

Former Member — Sat, 02 Jun 2007 11:35:39 GMT

Thanks Naveen.

I am implementing the BAdi LEDSP_SPLIT_EXECUTE in the same way, it's also for outbound delivery split.

My problem is that When I set a break point in my code within this BAdi ( method Execute ) & execute the Tcode VLSP, it's doesn't stop at that point means BAdi is not getting triggered from that Tcode.

Do you have any idea why it happens ?

Thanks,

SA.

Re: BAdi - LEDSP_SPLIT_EXECUTE

uwe_schieferstein — Sun, 03 Jun 2007 06:37:06 GMT

Hello Smita

Have you checked that your implementation of the BAdI is indeed activated? Go to transaction SE19, give the name of your implementation (NOTE: not the class name implementing the interface) and start the transaction. Next to the implementation name you see if it is either Active or Inactive.

If your implementation is active then you should stumble across the break-point in method EXECUTE.

Regards

Uwe