topic Re: reports in Application Development and Automation Discussions

reports

Former Member — Tue, 22 May 2007 11:37:53 GMT

Hi,

I have declared a select-option variable.

At field validation level what is the need to do for field-low value validation and field-high value validation. Instead of that cant we do the complete field validation.

Regards,

siri

Re: reports

sreeramkumar_madisetty — Tue, 22 May 2007 11:40:18 GMT

Yes you can do the complete field validation.

Suppose for Plant we do the complete validation not plant-low/plant-high validations in general.

Regards,

Sreeram

Re: reports

Former Member — Tue, 22 May 2007 11:41:26 GMT

Hi,

The standard way of doing it is by comparing the s-low and s-high values.

You can do it by the statement

if s_xxxx in (v_low(lower limit), v_high (Upper limit))

.........

endif.

Re: reports

Former Member — Tue, 22 May 2007 11:42:06 GMT

just use like :

at selection-screen on s_matnr.

select * from matnr from mara into mara

where matnr in S_matnr.

Re: reports

Former Member — Tue, 22 May 2007 11:42:52 GMT

hi,

U can do it bys uding

IN

keyword.

use ranges.fill the ranges with required values.

Then i code, u check the select option values are in this range or not.

so u can use complete field validation.

rgds

reshma

Re: reports

Former Member — Tue, 22 May 2007 11:43:09 GMT

Hi,

Yes you can use it as a single variable as select options values are stored in

the form of a table whereby high and low only specify the range.

Re: reports

Former Member — Tue, 22 May 2007 11:44:21 GMT

u can do validation for the selection field at a time.

sometimes it is that this way u have to validate.....

only low field is specified and high field is not specified. then need to do validation for low-field.

only high field specified and low field is empty, then need to do validation for high-field.

when both are speciifed, need to do validation in one instance.

Re: reports

Former Member — Tue, 22 May 2007 11:47:23 GMT

Here is sample code for validations, no need to validate saparetely.It will take care of both low and high.

DATA :

g_matnr TYPE matnr.

SELECT-OPTIONS:

s_matnr FOR g_matnr.

Atselection-screen:

DATA l_matnr TYPE matnr. " Material

SELECT matnr

INTO l_matnr UP TO 1 ROWS

FROM mara

WHERE matnr IN s_matnr.

ENDSELECT.

IF sy-subrc <> 0.

Incorrect material number entered

MESSAGE e002 .

ENDIF.

-SAKR