topic Re: Forms in Application Development and Automation Discussions

Forms

Former Member — Thu, 17 May 2007 16:49:22 GMT

can anyone tell me how to modify std Form f150_dunn_01

I have copied and did the modifications.....

Then in NACE.........how do I select my output type.........under which category ll i get...

And how do i assign the new output type in appropriate application and then to this output type link my SMARTFORM and driver program.............?????????

Can u give me the steps

Re: Forms

Former Member — Thu, 17 May 2007 16:57:33 GMT

this is a FI form for dunning letter .

NACE is related to LOGISTIC modules Output

This Fi transactions are not fired using output type

No need of any output type required for this

Check the transaction <b>OB96</b> for the assignment of Programs to forms in FI

Reward points if useful

Regards

Anji

Message was edited by:

Anji Reddy Vangala

Re: Forms

Former Member — Fri, 18 May 2007 12:48:05 GMT

Ya but OB96 Trans code..........I form i wanted is not there f150_dunn_01........

Wat ll i actually do using this OB96......