topic Reg:selection screen in Application Development and Automation Discussions

Reg:selection screen

Former Member — Mon, 07 May 2007 05:06:04 GMT

Hi Friends,

Please tell me the answer of the following question:

suppose two push buttons(p1 & p2) are there and two selection screens(s1 & s2) are there....When p1 is pressed s1 will remain acitve but s2 will be grayed out...similarly when p2 is pressed s2 will remain active but s1 wiil be grayed out.

what will be the coding for this.....

Re: Reg:selection screen

Former Member — Mon, 07 May 2007 05:08:58 GMT

u need to code in at selection screen output

when push btn 1

then screen 1 'active'

else

screen 2 'active

regards

anjlai

Re: Reg:selection screen

Former Member — Mon, 07 May 2007 05:09:47 GMT

hi Reema,

This some what similar to your requirement. Please check for the same.

Regards,

Santosh

Re: Reg:selection screen

former_member673464 — Mon, 07 May 2007 05:18:03 GMT

hi..

Gourp the elements in the selection-screen to same modif id.In at selection-screen output you can change the propeties of the screen using the modif id and use loop at screen for your use.

regards.

veeresh

Re: Reg:selection screen

Former Member — Mon, 07 May 2007 05:20:07 GMT

Hi Reema,

Refer this code :

SELECTION-SCREEN BEGIN OF BLOCK a1 WITH FRAME TITLE a1title.

parameters : d_matnr like mara-matnr.

SELECTION-SCREEN PUSHBUTTON1 50(10) txt1 USER-COMMAND com1.

parameters : d_vbeln like vbak-vbeln.

SELECTION-SCREEN PUSHBUTTON2 50(10) txt2 USER-COMMAND com2.

SELECTION-SCREEN END OF BLOCK a1.

Loop at screen.

If PUSHBUTTON1 <> 'X' and screen-value = d_matnr.

screen-active =0.

modify screen.

elseif PUSHBUTTON2 <> 'X' and screen-value = d_vbeln..

screen-active =0.

modify screen.

endif.

endloop.

read help on screen structure........

reward points if helpful.

Regards,

Hemant

Re: Reg:selection screen

Former Member — Mon, 07 May 2007 05:45:56 GMT

U can code like this....

TABLES sscrfields.

.....

AT SELECTION-SCREEN OUTPUT.

CASE sscrfields.

WHEN 'BUT1'.

loop at screen.

if screen-name = 's2' .

screen-active = '0'.

modify screen.

endif.

endloop.

WHEN 'BUT2'.

loop at screen.

if screen-name = 's1' .

screen-active = '0'.

modify screen.

endif.

endloop.

ENDCASE.