topic Function Group? in Application Development and Automation Discussions

Function Group?

Former Member — Fri, 20 Apr 2007 17:05:10 GMT

Hi, guys:

I create a function group, within it, I create a normal sreeen.

It has PBO/PAI.on the screen, there are several button.

I already assign Function Code to them.

when run this transaction code, click button, why no any

response. is there place to setup something

Thanks,

Victor

Re: Function Group?

Former Member — Fri, 20 Apr 2007 17:08:18 GMT

Did you assign the function code to the button in the screen layout and used the same function code in the program. Please chek this.

Shreekant

Re: Function Group?

Former Member — Fri, 20 Apr 2007 17:09:11 GMT

It's not only assigning the fucn. code to them but you also have to write a code in PAI module what should happen after click on these buttons.

no more setup is required for this only Func. code.

Regards,

Amey

Re: Function Group?

Former Member — Fri, 20 Apr 2007 17:15:22 GMT

Hi, Shreekant:

Thanks a lot. actually I check it many time, everthing is there,

I don't know why. anyway thank you for your quick reponse.

Regards,

Victor

Re: Function Group?

prabhu_s2 — Fri, 20 Apr 2007 18:11:49 GMT

Zhang

just try to debug it....u can find out where u are missing on the control

Re: Function Group?

Former Member — Fri, 20 Apr 2007 18:24:12 GMT

Hi!

try to debug it and find whether the ID is sent to the ok-code... anyway you can try to use sy-ucomm directly... another solution, carefully check writing of the names in screen-painter and in the PAI. try to write one name & copypaste it everywhere where it is used.

if the advice was successfull, inform me about it, please!

good luck!!