topic Re: Assign a Transaction code to a Z program in Application Development and Automation Discussions

Assign a Transaction code to a Z program

Former Member — Wed, 02 May 2007 07:08:06 GMT

Dear all,

I had assigned a t-code to a new developed zprogram. When I enter a tcode to call the program, input selection criteria and run execution, the program had no response, then auto back to the initial R/3 interface. However, if i use SE38 to run the same program, the program can continuously process and output the result successfully.

Do anyone know what happen/ problems in this case?

Best regards,

Chris

Re: Assign a Transaction code to a Z program

Former Member — Wed, 02 May 2007 07:10:42 GMT

Hi,

Goto SE93 and assign the tcode to the corresponding developed program and select the option as report.

Regards

Kannaiah

Re: Assign a Transaction code to a Z program

Former Member — Wed, 02 May 2007 07:12:18 GMT

HI,

Use the option Program and selection screen Radio Button and create the Tcode. It will work fine. I think you have selcted the wrong one while creating the tcode.

Regards,

Ram

Re: Assign a Transaction code to a Z program

Former Member — Wed, 02 May 2007 07:12:39 GMT

Open the code ..program in Se80 and then right click on the rpgram name goto ..create and then Transaction and then please assign the transactioncode gaian.......

I think that the T code you created was not attached to your program .... I think doing it again will help you..

Ragards,

Jayant

Message was edited by: Jayant

JAYANT KUMAR

Re: Assign a Transaction code to a Z program

Former Member — Wed, 02 May 2007 07:12:56 GMT

Hi,

go to se93 give your z transaction name press create it choose the 2nd radio button with report give your your report name next screen.

Regards

Sudheer

Re: Assign a Transaction code to a Z program

Former Member — Wed, 02 May 2007 07:37:04 GMT

Dear all,

I have already assigned the tcode to the program, if I want to change the radio button to PROGRAM AND SELECTION SCREEN (REPORT TRANSACTION), how should I do it?

I cannot not check this option in an existing dialog transaction (SE93)

Chris

Re: Assign a Transaction code to a Z program

Former Member — Wed, 02 May 2007 07:39:21 GMT

Hi,

Remove the previous TCODE and create new and check the report option.

Regards

Kannaiah

Re: Assign a Transaction code to a Z program

Former Member — Wed, 02 May 2007 07:40:21 GMT

Goto SE93
Give the TCODE name and click on change button
In menu Edit--->Change Transaction Type

Re: Assign a Transaction code to a Z program

Former Member — Wed, 02 May 2007 07:42:52 GMT

I am not sure about your question you can go to se93 and give yor transaction code and go to change mode check menu path edit--> change transaction type (shift+F1)

regards

shiba dutta