topic Re: Stop statement... in Application Development and Automation Discussions

Stop statement...

Former Member — Wed, 18 Apr 2007 11:30:12 GMT

After STOP statement which event is triggered in Report?

Re: Stop statement...

Former Member — Wed, 18 Apr 2007 11:30:46 GMT

END-OF-PAGE

AT SELECTION-SCREEN (without additions)

START-OF-SELECTION

GET

You leave these event blocks via STOP, and the runtime environment triggers the event END-OF-SELECTION.

Santhosh

Message was edited by:

Kaluvala Santhosh

Re: Stop statement...

Former Member — Wed, 18 Apr 2007 11:43:55 GMT

If you use the STOP statement within an event block, the system stops processing the block immediately. The ABAP runtime environment triggers the next event according to the following diagram:

INITIALIZATION.

STOP --> SELECTION-SCREEN

START-OF-SELECTION OR GET

STOP. --> END OF SELECTION

END OF SELECTION

STOP --> OUT OF PROGRAM

REPORT EVENT_TEST.

NODES: SPFLI, SFLIGHT, SBOOK.

START-OF-SELECTION.

WRITE 'Test program for STOP'.

GET SBOOK.

WRITE: 'Bookid', SBOOK-BOOKID.

STOP.

END-OF-SELECTION.

WRITE: / 'End of Selection'