topic dynamic display on selection screen in Application Development and Automation Discussions

dynamic display on selection screen

Former Member — Wed, 04 Apr 2007 05:32:49 GMT

Hi All,

I have a tabbed block on the selection screen and need to display fields from an internal table dynamically using a step loop.

What I have done is, fill the Internal table in PBO of the 1st tab screen ie 100 screen, then initiated a loop for this internal table and inside the loop called a step loop for display of these fields.

But not able to display. Also in initialization, i have initiazed mytab-dynnr = 100.

Thanks.

Re: dynamic display on selection screen

Former Member — Wed, 04 Apr 2007 05:38:15 GMT

hi kiret

u can create a table contro using a table control wizard

instead of steps loops use table control it has may advantages than step loops

regards

navjot

Message was edited by:

navjot sharma

Re: dynamic display on selection screen

former_member673464 — Wed, 04 Apr 2007 05:44:30 GMT

hi,

In pbo modules declare tabstrip-activetab = function code of the tab where tabstrip is the tabstrip in the screen .Declare area of the screen as area1. CALL SUBSCREEN: area1 INCLUDING SY-REPID '0100'.For table control you can use loop with control statements to display fields of a table.

Message was edited by:

veereshbabu ponnada