topic Re: RE Table Update program with tcode .. in Application Development and Automation Discussions

RE Table Update program with tcode ..

Former Member — Fri, 16 Mar 2007 09:54:38 GMT

friends i had done a update program for HR module pa0267 and using ldb

but when i run this program in se38 the it workks fine ..but if i run this program trough tcoe i get the selection screen and when i run it it throws me out not even on se38 .

regards

Re: RE Table Update program with tcode ..

amit_khare — Fri, 16 Mar 2007 09:58:45 GMT

Check your tcode parameters.

Did you check the Report Selection.

Regards,

Amit

Re: RE Table Update program with tcode ..

Former Member — Fri, 16 Mar 2007 10:04:36 GMT

hAI

When u create tcode must select sencond option

PROGRAM AND SELECTION SCREEN.

**Please reward suitable points***

With Regards

Navin Khedikar

Re: RE Table Update program with tcode ..

Nawanandana — Fri, 16 Mar 2007 10:09:45 GMT

hai

i think u hav the problem of T-CODE parameter.... so u go the se38 and then go to Display object list(CtrlShiftF5)... then delete the T-CODE and creat again new t code abd try again.... after that go to se 93 and checked ur program coz some time ur program should be error... of any wrong program plz put the correct program and save then run the tcode... I think i wil be wk now....

regard

nawa.

Re: RE Table Update program with tcode ..

Former Member — Fri, 16 Mar 2007 10:15:38 GMT

Thanks ,

solved it