topic Re: Outbound idoc in Application Development and Automation Discussions

Outbound idoc

Former Member — Wed, 14 Mar 2007 11:22:24 GMT

I have created a new message type & linked it.

Now the idoc is generated successfully in the source system but not distributed in the target system.

in target system too i specified the partner profile.

May i know wats the error.

Thanks in advance.

Re: Outbound idoc

Former Member — Wed, 14 Mar 2007 11:30:00 GMT

Two possible reasons,

1. The distribution model is not defined or cantains errors.

2. Message type does not exist in the target.

Check these out

Re: Outbound idoc

Former Member — Wed, 14 Mar 2007 11:30:05 GMT

hello,

check the CDMA part and it should be disitributed.

Re: Outbound idoc

Former Member — Wed, 14 Mar 2007 11:31:32 GMT

cdm is distributed in the target system & in the target system also i have this message type.

Re: Outbound idoc

Former Member — Wed, 14 Mar 2007 12:04:42 GMT

could u specify more briefly?

Re: Outbound idoc

Former Member — Wed, 14 Mar 2007 12:10:36 GMT

Whats the status of the idoc in the source and the target system ?

if source(sending logical system) idoc is 53 and target status(Receiving LS) of idoc <> 53

check the error status ..

regards,

Vijay

Re: Outbound idoc

former_member404244 — Wed, 14 Mar 2007 12:17:14 GMT

hi,

did u created model view in BD64 and distributed it.....chek the same..

regards,

nagaraj

Re: Outbound idoc

Former Member — Wed, 14 Mar 2007 12:36:55 GMT

HI,

Check your Source & target system

It should have same settings in both systems

Check for all the following :

message type

Idoc type

rfc connection

partner profile

SAP version

Thanks

Sunil