topic Re: abap debugging in Application Development and Automation Discussions

abap debugging

Former Member — Tue, 13 Feb 2007 08:40:49 GMT

whats the function of f6 and f7 keys in debugging

regards

rose

Re: abap debugging

Former Member — Tue, 13 Feb 2007 08:43:01 GMT

F6-----Debugs each line

F7---- When there is subroutine and you want to skip that , use F7

Re: abap debugging

Former Member — Tue, 13 Feb 2007 08:43:09 GMT

F6 - Execute - Will execute a form, FM instead of single step.

F7 - Return - Will return to the peice of code that called the function, form etc

Re: abap debugging

Former Member — Tue, 13 Feb 2007 08:43:32 GMT

F6 - Execute to the next line

F7 - Return back to the calling block

Re: abap debugging

Former Member — Tue, 13 Feb 2007 08:44:04 GMT

<b>F6 is double step execution</b>, if u r executing a report when u see a perform if u press F5 it will go inside the form, if u press F6 it will skip and go to the next line.

If u have gone inside teh form and if u want to come out immediately then press F7.

Similarly if u r inside a FM or inside any loop pressing F7 will take u out from that loop.

Hope u r clear about this.

Reward points if this helps.

Re: abap debugging

Former Member — Tue, 13 Feb 2007 08:47:18 GMT

Hello,

1. F5 - Line by line

2. F6 - Line by line, but if a line is PERFORM or FUNCTION then the control will

not go inside.

3. F7 - If u r inside a perform or Function module and if u press F7 it will come out

of the perform or function module and continues with the next line after

perform or function call line.

Regs,

Venkat Ramanan N

Re: abap debugging

Former Member — Tue, 13 Feb 2007 08:54:06 GMT

good

F6- Jump one step ahead fromthe current line

F7-It Shifts between the screens

thanks

mrutyun^

Re: abap debugging

Former Member — Tue, 13 Feb 2007 09:13:29 GMT

F6-> Debugs single step. If there is any processing module like function module or subroutine, it will not enter the subroutine instead just execute whatever the code is.

F7-> This is used to execute all statements in current processing block like subroutine or function module and move out of the current processing block.

Regards,

Navin

Re: abap debugging

abhishek_gupta2 — Tue, 13 Feb 2007 10:23:30 GMT

hi ,

there are three debugging keys F5 , F6 , F7 .

F5 : this is used for debugging line by line of the code .

F6 : This is also line by line but when the line is PERFORM or FUNCTION MODULE , it does not enters into the corresponding form and FM, in case of F5 , it will enter in the corresponding blocks of code .

F7 : now suppose you were debugging and entered in the loop or subroutine and want to come out of it , press F7.

cheers.