topic Re: date in Application Development and Automation Discussions

date

Former Member — Wed, 07 Feb 2007 04:54:05 GMT

Hi all,

How can I restrict my output so that my end date is always greater than my start date.

E.g. 01/01/06 to 01/01/07 -

> should work

01/01/06 to 01/01/01 -

> shouldn't work

Re: date

Former Member — Wed, 07 Feb 2007 04:55:40 GMT

Hi,

Check if ENDDA > BEGDA....

You can check the dates directly.

Regards

Subramanian

Re: date

Former Member — Wed, 07 Feb 2007 04:55:55 GMT

Use this code:

IF enddate GE begindate.

Continue

ELSE.

Error

ENDIF.

Re: date

Former Member — Wed, 07 Feb 2007 04:57:33 GMT

Hi,

Check this..

If the variable is date type..Then you can directly compare..

Example

DATA: V_DATE_FROM TYPE SYDATUM.

DATA: V_DATE_TO TYPE SYDATUM.

V_DATE_FROM = SY-DATUM.

V_DATE_TO = SY-DATUM + 1.

IF V_DATE_FROM > V_DATE_TO.

WRITE: / 'V_DATE_FROM IS GREATER'.

ELSE.

WRITE: / 'V_DATE_TO IS GREATER'.

ENDIF.

Thanks,

Naren

Re: date

Former Member — Wed, 07 Feb 2007 04:57:41 GMT

Hi,

system wont accept the low value in higher range

It will give an error message like this

Lower limit is greater than upper limit

Regards

Shiva

Re: date

Former Member — Wed, 07 Feb 2007 05:03:23 GMT

Hi,

If you are getting values through select options and need to use then you need no thave to do anything the select options takes care.

if this is not the case and if you want to code or check it then put a if condition there if begda LE endda.

.................

else.

exit.

endif.

Thanks,

Prashanth

Re: date

Former Member — Wed, 07 Feb 2007 05:15:03 GMT

Hi,

I hope by default itself it will check for the low value should not be greater than high value. if it is not then try this.

select-options: s_date for <fieldname>.

At selection-screen on s_date.

If s_date-high < s_date-low then

message i000(00) with 'End date cannot be less than Start date'.

endif.

Hope this will help u.

Regards,

U. Uma