topic Re: debugging in Application Development and Automation Discussions

debugging

Former Member — Fri, 16 Feb 2007 07:52:02 GMT

how to debug the transaction code

Re: debugging

Former Member — Fri, 16 Feb 2007 07:54:21 GMT

before executing the tcode just execute '/h' command and then execute the transaction

regards,

Santosh

Re: debugging

Former Member — Fri, 16 Feb 2007 07:56:01 GMT

Hi,

/H will debug the from first statment or else put the Break point in that program and run the Trasaction code, then the program will stop.

You can see the program, System --> Status and find the program and put the break point

Regards

Sudheer

Re: debugging

Former Member — Fri, 16 Feb 2007 07:57:11 GMT

in the top left hand corner type /h and press enter , then it will take to debugging screen of ur transaction code

Re: debugging

andreas_mann3 — Fri, 16 Feb 2007 07:57:47 GMT

HI;

GoTo. SYSTEM - UTILITIES - debug abaap / system

Re: debugging

Former Member — Fri, 16 Feb 2007 08:11:10 GMT

Hi,

You can debug a transaction either by typing '/h' before executing the transaction code or put a debugging point in the program associated with the Tcode and then execute the Transaction code.

Regards,

Sowmya.

Re: debugging

Former Member — Fri, 16 Feb 2007 08:16:50 GMT

good

to debug a tcode you whould know the program name for which this tcode has been created and than you can debug that standard program or the zprogram using \h or using the break point.

Thanks

mrutyun^

Re: debugging

Former Member — Fri, 16 Feb 2007 08:22:19 GMT

Download this document

http://www.sappro.com/downloads/Settings&SystemAreas.pdf

Regards

Shiva

Re: debugging

Former Member — Fri, 16 Feb 2007 08:24:26 GMT

Hi,

There are two possible strategies for starting the Debugger in the ABAP Workbench:

1)By setting breakpoints then running the program

2)By running the program in debugging mode.

If you want to debug the transaction from starting then you can put '/h' in command and then you execute the transaction .It goes into debugging mode.

open the program of that trnsaction and put a break point on the line where you want to debug, by selecting 'STOP' button from application tool bar or pressing 'CTRLSHIFTF12'

Regards,

Sruthi

Re: debugging

sreeramkumar_madisetty — Fri, 16 Feb 2007 08:54:26 GMT

Before executing the Tcode press /h in the command promt and then press F8.

Now the debugging of the Tcode is switched on.

Regards,

kumar

Re: debugging

Former Member — Fri, 16 Feb 2007 09:36:20 GMT

Hello,

Before executing a transaction, typer /h in the command and press enter. Now execute ur desired transaction to debug.

Regs,

Venkat Ramanan N