Standard transaction

manubhutani — Thu, 01 Mar 2007 06:09:06 GMT

I have copied the standard transaction and have changed the includes to zincludes but when i open the program none of the includes are renamed to zincludes.. and also when i run the z transaction of my zprogram it says that entry not maintained in t180 table.. n i am unable to enter in this table..

Plzzzz help me out.. waitin eagerly 4 ur reply..

Re: Standard transaction

Former Member — Thu, 01 Mar 2007 06:20:06 GMT

Hi,

While copying the standrad program, did you select the INCLUDES checkbox, It will give popup with all includes and specify ZINCLUDE name

Go to SE80 --> Open the program name ---> Activate the program

Create transaction code --> save & Execute

I believe you have done coping as mentioned above.

Coming to your problem, It might be happen because of unactive includes are there. Please check in SE80 and activate all.

I hope your problem is resolved. If so, plz reward points. If you wan't more help please specify the program name.

Regards

Bhupal Reddy

topic Standard transaction in Application Development and Automation Discussions

Standard transaction

Re: Standard transaction