topic Re: why the value table doesn't work? in Application Development and Automation Discussions

why the value table doesn't work?

peter_peng — Thu, 25 Jan 2007 08:59:58 GMT

code:

tables: cepc.

selection-options: sele_prctr for cepc-prctr.

because there is a value table defined in domain PRCTR, so I think I can only input the data that exists in table cepc.

but now I can input anything into this field in selection screen.

could anyone tell me why? thank you!

Former Member — Thu, 25 Jan 2007 09:02:51 GMT

You can enter any value for the Selection Screen field .

If you do not want to add a validation for the same in the AT SELECTION-SCREEN event.

This will not allow further processing unless the value is from the value table.

Hope this helps

seshatalpasai_madala — Thu, 25 Jan 2007 09:04:23 GMT

Hi,

You need to give VALUE CHECK addition to the PARAMETERS: then only the check will happen.

Regards,

Sesh

Message was edited by:

Seshatalpasai Madala

Former Member — Thu, 25 Jan 2007 09:10:33 GMT

The value table for domain PRCTR is the same table CEPC. you can eneter any value but the validation will be done based on your inputs

Thanks

Shiva

peter_peng — Thu, 25 Jan 2007 09:11:11 GMT

that is, the value table doesn't work for this?

seshatalpasai_madala — Thu, 25 Jan 2007 09:47:31 GMT

Hi,

If it is PARAMETERS then VALUE CHECK could have worked. I dont think there is any way for doing the same with SELECT_OPTIONS.

Regards,

Sesh