topic MM doubt in Application Development and Automation Discussions

MM doubt

Former Member — Wed, 31 Jan 2007 04:38:22 GMT

what is the difference between component and sub-assembly in MM ?

my requirement in report is, if component entered then get sub-assemblies using the FM CS_*BOM_EXPLOSION. if it is in other way, ie. entering sub-assebly in the screen it should not pick anything.

where can I get this information? plz help me..

Re: MM doubt

Former Member — Wed, 31 Jan 2007 04:45:03 GMT

check this

Regards

Prabhu

Re: MM doubt

p291102 — Wed, 31 Jan 2007 04:48:41 GMT

Hi,

One product have 'N' no.of components and One component have "N' no.of sub-assemblys.

In One SUB-ASSEMBLY have one or more no of. small parts will contain.

For example ONE BOLT is there. It is one of sub-assembly it having nut and washer is there.

This one bolt is the one part for one component or product.

Thanks,

Shankar

Re: MM doubt

Former Member — Wed, 31 Jan 2007 05:12:55 GMT

The details in my selection screen are:

I have material and plant... disposition ( R-Rework, S-scrap, U-use as is...) and cost of rework ie. either standard or moving avg price...or the cost enter in the selection screen.

So, which FM is suitable to get sub-asseblies either CALL

FUNCTION 'CS_BOM_EXPL_MAT_V2' or CS_*BOM_EXPLOSION? plz help me..

I can only pass material and plant is input parameters...

Re: MM doubt

Former Member — Wed, 31 Jan 2007 05:31:46 GMT

fm CS_BOM_EXPL_MAT_V2 is the correct one.

here you need to pass minimum

capid = 'PP01'.

mtnrv = <material no>.

datuv = sy-datum.

werks = <plant>.

if you want multi level bom

then

mehrs = 'X'.

regards

shiba dutta