topic Re: Question reg. message on selection screen in Application Development and Automation Discussions

Question reg. message on selection screen

Former Member — Wed, 29 Nov 2006 23:11:33 GMT

Hi,

On selection screen, I want to display a status message if the data is not found from the values the user entered. I wrote the following coding. I am able to get the message but it is coming out in the output rather than on the selction screen itself. Can you tell me what correction I can make to get the desired result?

IF p_vbeln IS not INITIAL.

SELECT vbeln erdat FROM vbak

INTO CORRESPONDING FIELDS OF TABLE itab_vbeln

WHERE vbeln = p_vbeln.

endif.

IF sy-subrc <> 0.

MESSAGE s004(zer) WITH 'No data found'.

ENDIF.

Thank you very much,

Krishen

Re: Question reg. message on selection screen

Former Member — Wed, 29 Nov 2006 23:14:31 GMT

Hi,

Add leave list-processing after the success message..

IF p_vbeln IS not INITIAL.

SELECT vbeln erdat FROM vbak

INTO CORRESPONDING FIELDS OF TABLE itab_vbeln

WHERE vbeln = p_vbeln.

endif.

IF sy-subrc <> 0.

MESSAGE s004(zer) WITH 'No data found'.

<b>LEAVE LIST-PROCESSING.</b>

ENDIF.

Thanks,

Naren

Re: Question reg. message on selection screen

RichHeilman — Wed, 29 Nov 2006 23:16:00 GMT

Please do your coding in the AT SELECTION-SCREEN event.

AT Selection-Screen.

IF p_vbeln IS not INITIAL.
SELECT vbeln erdat FROM vbak
INTO CORRESPONDING FIELDS OF TABLE itab_vbeln
WHERE vbeln = p_vbeln.
endif.

IF sy-subrc <> 0.
MESSAGE s004(zer) WITH 'No data found'.
ENDIF.

Regards,

Rich Heilman