topic Re: Submit Statement with User ID ? in Application Development and Automation Discussions

Submit Statement with User ID ?

Former Member — Fri, 15 Dec 2006 07:22:08 GMT

Hii All

I need helpon how the user authentication works for SUBMIT statement

as given below.

SUBMIT REPORTNAME AND RETURN

USER SY-UNAME VIA JOB JOBNAME NUMBER JOBNUMBER

Is this to use the authentication for running the back ground processing

using the User ID given

The authentication is for all the JOB steps in that job to be done by using the User ID Authentication stated in the statement ?

I think i am clear with my question??

if not i can clarify on it again...

Thanks

Ajitabh

Re: Submit Statement with User ID ?

Former Member — Fri, 15 Dec 2006 08:16:48 GMT

Hi Ajitabh

The authentication acts for the particular step where we are defining...

To understand more you can check parameter: <b>AUTHCKNAM</b> of FM: <b>JOB_SUBMIT</b>

Kind Regards

Eswar

Re: Submit Statement with User ID ?

Former Member — Fri, 15 Dec 2006 09:37:01 GMT

Hii Eswar

Thanks for your reply ...

But i am using the SUBMIT Statement ....Instead of JOB_SUBMIT...

I am using SUBMIT because i want to fill up some input parameters with this JOB Step which is a program with selection screen.

can i use JOB_SUBMIT for doing the same..

Can u help me out on this ..

Ajitabh

Re: Submit Statement with User ID ?

Former Member — Fri, 15 Dec 2006 09:45:06 GMT

Hi Ajitabh

If the values are going to be fixed always, we can create and variant and use the same in FM: JOB_SUBMIT.

If the values differ, we can use the SUBMIT statement and pass values. Addition ... USER user VIA JOB job NUMBER n helps to create the step with a specific user-id. I guess, this acts for the particular step in the job and not for all steps.

Kind Regards

Eswar