topic Re: Document Management distribution workflow in Application Development and Automation Discussions

Document Management distribution workflow

pbechani — Tue, 28 Nov 2006 14:07:53 GMT

I have activated the document management distribution workflow. When I start the documenent distibution the workflow is not started. When I go back to check the started of the workflow in spro it will be deactivated.

How can I activated it permanently or is there some configuration that need tobe done?

Points will be awarded.

Re: Document Management distribution workflow

Former Member — Tue, 28 Nov 2006 15:37:33 GMT

hi,

While activating the workflow for the option 'Behavior Upon Error Feedback' choose 'Do not change linkage'.

If this does not help, give me more info on how you are activating this workflow.

regards,

Sreecharan

Re: Document Management distribution workflow

pbechani — Wed, 29 Nov 2006 09:07:02 GMT

Hie Sreecharan. It is not working. The workflow is continuously being deactivated.

I am activating it in spro, under 'Perform task-specific Customizing'. Under CA, I go to Document Management and click on Activate Event Linking.

I expand WS20000104 and click on deactivate and it displays a green buttonthat it is activated.I then click on the properties of the event linkage button. and followed your instructions. The save button will be disabled. When I close the dialog box, on re-opening it, it would have defaulted to 'System presetting'.

Help.

Re: Document Management distribution workflow

Former Member — Wed, 29 Nov 2006 09:23:41 GMT

ok now check what is the system presetting,

open transaction SWEQADM - choose tab 'Basic data' and check what is the setting for 'Receiver error feedback'.

if you have authorization to change then choose option 'Do not change linkage' for this if not ask someone who has auth to do it.

regards,

Sreecharan.

Re: Document Management distribution workflow

pbechani — Wed, 29 Nov 2006 11:03:26 GMT

Thank you very much Sreecharan. My problem now is that in workflow builder I test the workflow and I am getting the following error message 'The mandatory input parameters of the workflow must be set'.

I test the same workflow in development and it is running. What can I do ?

Re: Document Management distribution workflow

Former Member — Wed, 29 Nov 2006 11:31:30 GMT

please create a new thread for this. one thread is for one question only.