IDoc Creation Issue

Former Member — Fri, 10 Nov 2006 09:55:44 GMT

Hi All,

I am facing an awkward problem. I created a Partner Profile for a Customer and assigned the Message Type 'DESADV' to it.

Then I created a Delivery For the Customer corresponding to a created Sales Order .

I put a break-point on the Corrseponding Function Module IDOC_OUTPUT_DESADV01 which got associated with the Partner Profile. I was hoping that it would stop at the break-point. But it didnt and an IDoc got created.

I tried to put the break-points at various locations in the Function Module but it was of no use. Every time IDoc got created without stopping at the break-point.

As per my understanding, the data in the IDoc gets filled only using the associated Function Module. But, I am not able to understand the reason why we are not able to put a break-point in this Function Module and see the processing.

Please advise on the issue. Is there any alternate way also by which an IDoc gets filled.

Thanks a lot in advance.

Re: IDoc Creation Issue

Former Member — Fri, 10 Nov 2006 10:07:28 GMT

In tcode we57..

IDOC_OUTPUT_DESADV1 has been assigned to DESADV.

i m not sure but check that..

santhosh

Re: IDoc Creation Issue

Former Member — Fri, 10 Nov 2006 10:10:59 GMT

Hi,

Please try out the function module :

/SAPNEA/IDOC_OUTPUT_DESADV01 as this is the latest version of it.

hope it helps

thanks

topic Re: IDoc Creation Issue in Application Development and Automation Discussions

IDoc Creation Issue

Re: IDoc Creation Issue

Re: IDoc Creation Issue