topic Re: Continue statement in Application Development and Automation Discussions

Continue statement

Former Member — Fri, 27 Oct 2006 14:05:41 GMT

Please explain me what this continue statement do here.

IF lt_capreq[] IS INITIAL.

CONTINUE .

ENDIF.

LOOP AT lt_capreq ASSIGNING <lt_capreq> .

CHECK <lt_capreq>-act_status NE 6.

CHECK <lt_capreq>-acttype EQ 'P'.

MOVE <lt_capreq>-orderid TO wa_opr_key-orderid.

MOVE <lt_capreq>-oprcounter TO wa_opr_key-oprcounter.

APPEND wa_opr_key TO lt_opr_key_tab. "Has OrdID

ENDLOOP.

Re: Continue statement

Former Member — Fri, 27 Oct 2006 14:07:28 GMT

Hi,

It continues to loop to next record.

Regards,

Ferry Lianto

Re: Continue statement

Former Member — Fri, 27 Oct 2006 14:07:28 GMT

hi John,

CONTINUE terminates the current loop pass, returns the processing to the beginning of the loop and starts the next loop pass, if there is one.

Regards,

Santosh

Re: Continue statement

venkata_ramisetti — Fri, 27 Oct 2006 14:07:36 GMT

Hi,

If you use CONITINUE in the LOOP...ENDLOOP, it will skip the following code that exists till ENDLOOP. and control goes again to the starting of LOOP to process the subsequent record.

IF just want comeout from LOOP..ENDLOOP use EXIT

Thanks

Ramakrishna

Re: Continue statement

Former Member — Fri, 27 Oct 2006 14:09:15 GMT

Hi Johnn,

If lt_capreq[] IS INITIAL.

CONTINUE . This will come out of this current loop processing and go to next loop process.

ENDIF.

Reward points if this helps.

Manish

Re: Continue statement

Former Member — Fri, 27 Oct 2006 14:10:52 GMT

Normally we dont use continue statment whithout a loop.

DO 100 TIMES.

IF SY-INDEX >= 10 AND SY-INDEX <= 20.

CONTINUE.

ENDIF.

write:/ SY-INDEX.

ENDDO.

here write statement is not executed for SY-INDEX >= 10 AND SY-INDEX <= 20

for all other values it is executed.

continue statement without loop dont make any sense.

Re: Continue statement

Former Member — Fri, 27 Oct 2006 14:10:55 GMT

lets the internal table lt_caprep is initial with no contents ,

it doesn't process the below code in the loop and goes for the next iteration .

this will make u clear.

ex..

data : a type i value 2,

b type i value 3,

c type i value 4,

d type i .

do 2 times.

d = d + 1.

continue.

d = d + 3.

enddo.

regards,

Vijay

Re: Continue statement

Former Member — Fri, 27 Oct 2006 14:32:32 GMT

Are you using LDB in the below ABAP ?

If not the below statement does not have any impact.

Re: Continue statement

Former Member — Fri, 27 Oct 2006 14:38:21 GMT

Johnn,

you are using the continue in if statement?

continue can use in loop statement only.

in loop it skips the lines after continue statement and go to next record of loop.

-Anu