topic Re: Read Command in Application Development and Automation Discussions

Read Command

Former Member — Thu, 09 Nov 2006 14:42:44 GMT

Tell me abt Read Command in abap ?

Former Member — Thu, 09 Nov 2006 14:45:01 GMT

Hi Chitrakant,

The best will be Go into ABAP Editor(Se38)-> Go inside the program ->type <b>READ</b> ->keep cursor on READ stmt -><b>Do F1...</b>

Hope that helps.

Manish

Message was edited by: Manish Kumar

Former Member — Thu, 09 Nov 2006 14:46:36 GMT

Read statement is used to read a single line of an internal table.

For further information check the below link.

Former Member — Thu, 09 Nov 2006 14:49:05 GMT

READ command is used for to read one value or one row from internal table.

loop at itab.

read table itab1 with key f1 = itab-f1.

if sy-subrc = 0.

write:/ itab1.

endif.

endloop.

Mark points if helpful.

Regs

Manas Ranjan Panda

Message was edited by: MANAS PANDA

Former Member — Thu, 09 Nov 2006 14:51:25 GMT

Chitrakant,

1. Read statement you use for internal tables to get a single record by giving condition or index.

2 . GIve u sy-subrc value.

-Anu