topic Re: Debugging in Application Development and Automation Discussions

Debugging

Former Member — Mon, 20 Nov 2006 14:17:14 GMT

Hello Friends,

I want to Debug all the code that runs for MFBF transaction.

How can I do that.

Also How can I debug a dialogue program from the start.

Shejal.

Re: Debugging

Former Member — Mon, 20 Nov 2006 14:19:04 GMT

Type '/H' in the command line (where you type transaction code) and hit enter.

Then type the transaction code and start execution, it will go into debug mode.

Similarly wherever you want debugging, just type /h and start you can start debugging.

Regards,

Ravi

Note - Please mark all the helpful answers

Re: Debugging

Former Member — Mon, 20 Nov 2006 14:19:09 GMT

hi,

In the command field key in /h which would start the debugger

santhosh

Re: Debugging

Former Member — Mon, 20 Nov 2006 14:20:06 GMT

Hi,

this transaction calls the screen 800 of the program SAPLBARM. You can set a break-point in the first line of the first PBO module.

Regards,

Anand Mandalika.

Re: Debugging

Former Member — Mon, 20 Nov 2006 14:20:35 GMT

goto that transaction MFBF and after entering the input values , give /h at the top left and then press enter , this will taku you to debug screen , from there u can debug the whole transactino

Re: Debugging

Former Member — Mon, 20 Nov 2006 14:22:21 GMT

goto se93 and find the main program for your transaction. Get into the code and place the break point in the line where you want the control to stop.

then you can run the tcode as you would normally do, you would get into a debugging screen with all the options for debugging.

Regards,

ravi

Re: Debugging

Former Member — Mon, 20 Nov 2006 14:26:17 GMT

Hi,

Go to MFBF. Then click u r mouse near the LHS Enter Key. Type /h and press Enter. Debugger will be on Now value in some field and press enter it will go to code directly .

Cheers

Re: Debugging

Former Member — Mon, 20 Nov 2006 14:26:19 GMT

Thanks everyone. I will try and will get back if I have any questions.

Shejal.