topic Re: Zebra Z6Mplus printer with smartforms in Application Development and Automation Discussions

Zebra Z6Mplus printer with smartforms

christian_laber2 — Fri, 20 Oct 2006 14:55:54 GMT

Hello together,

I want to setup a Zebra Z6Mplus on our SAP R/3 Enterprise system.

Which driver I need to create a printer in the SAP System (z.B. LZEB3 or something like that)(TA:SDAD).

The printer is installed local on a desktop pc. From this pc it is possible to print everything with the Zebra printer.

But when I want to print in SAP (SmartForms) and with the printer "locl" there are no reaction from the printer.

Just the LED for "DATA" blink for a very short time. So I'm sure that a "data package" was send to the printer. But as I say ---> no reaction.

Can anybody help me??

Thanks!

Best regards

Christian

I have also read a post within this forum

Re: Zebra Z6Mplus printer with smartforms

Former Member — Fri, 20 Oct 2006 15:21:38 GMT

I had faced similar problem with zebra printer long back.

Are you using ZEBRA printer control language within smart forms ? if so check your control commands looks like something is missing or command is incomplete.

Re: Zebra Z6Mplus printer with smartforms

christian_laber2 — Tue, 24 Oct 2006 08:24:00 GMT

Thank's a lot. The printer works right

But now I have an addiational question.

Can I change the printing (180°)output within the Zebra Setup??, because the output is upside down??

Greets

Christian

Re: Zebra Z6Mplus printer with smartforms

FredericGirod — Tue, 24 Oct 2006 08:30:56 GMT

Do you have create the printer in the SPAD ?

Frédéric

Re: Zebra Z6Mplus printer with smartforms

christian_laber2 — Tue, 24 Oct 2006 08:34:43 GMT

Yes certainly?!

Why??

Re: Zebra Z6Mplus printer with smartforms

Former Member — Tue, 24 Oct 2006 08:35:46 GMT

Check the print control values set for the Zebra printer defined in SPAD.

Regards,

Raj

Re: Zebra Z6Mplus printer with smartforms

christian_laber2 — Tue, 24 Oct 2006 08:48:42 GMT

OK I have checked the values. But I can't find any interesting setting for my problem.

In the worst case, I need a new label roll which is reversed.

Regards

Christian

Re: Zebra Z6Mplus printer with smartforms

FredericGirod — Tue, 24 Oct 2006 09:09:42 GMT

Cause when you use the LOCL printer device you didn't need to create the printer in the SPAD ...

but Smartforms requiere a printer in the SPAD to print in other computer than the one connect to the printer ...

Fred

Re: Zebra Z6Mplus printer with smartforms

christian_laber2 — Tue, 31 Oct 2006 07:06:06 GMT

Hello @all,

now the Zebra printer is working well. But I still have one problem. The output from the printer is updside

down, as I wrote it a few topics above.

So from my side, I have two possibilities.

One the on hand, I buy other labels which are upside down and on the other hand I print the output in a 180° changed position.

I'm using smartforms und I have created the printer in SPAD. So what are my possibilities to solve my problem.

Or are there any possiblities within the printer-setup(hardware)??

Please help me.

The new printer want to go productiv.

Best regards

Christian