topic Re: parameter id - not working in Application Development and Automation Discussions

parameter id - not working

Former Member — Thu, 16 Nov 2006 09:34:17 GMT

hi all,

i have a program that should run from trans. iw52

i need to know the notification nnumber.so i wrote:

set parameter id 'p_qmnum' field qmel-qmnum.

GET PARAMETER ID 'iqm' FIELD p_qmnum.

and its not work.

what am i doind wrong?

thanks,

dana

Former Member — Thu, 16 Nov 2006 09:39:54 GMT

Use capitals and try again like this.

set parameter id 'IQM' field qmel-qmnum.

GET PARAMETER ID 'IQM' FIELD p_qmnum.

Regards,

Ravi

Former Member — Thu, 16 Nov 2006 09:40:03 GMT

Hi Dana,

Just write the code as under and it would work:

SET PARAMETER id 'iqm' FIELD qmel-qmnum.

here you are setting the field value of qmel-qmnum to id iqm.

GET PARAMETER ID 'iqm' FIELD p_qmnum.

Here you are setting the field p_qmnum with the value of id iqm.

You were using different memory id's for the process & so was not able to get the notification no.

Regards,

Chetan.

PS: Reward points if this is helpful.

Former Member — Thu, 16 Nov 2006 09:40:49 GMT

Hi Dana

Please see that you have declare as below:

<b>data: p_qmnum like RIWO00-QMNUM.

set parameter id 'IQM' field p_qmnum.

get parameter id 'IQM' field p_qmnum.</b>

Note that Parameter Id for Notification number is IQM and declaration of p_qmnum should be same in calling and callee programs.

Kind Regards

Eswar

Former Member — Sun, 19 Nov 2006 10:33:01 GMT

thank you all, it is working good.

thank you very much.

dana.

Former Member — Sun, 19 Nov 2006 10:34:10 GMT

it now working great. thanks.