topic Re: control break statement in Application Development and Automation Discussions

control break statement

Former Member — Tue, 10 Oct 2006 13:50:02 GMT

Hi All,

When I use control break statements in the loop, I could get * in the output display for the field, which I set the AT New operation.

I sorted the internal table with the primary key, consequently with the other fields in order.

Still, I get * in the output.

Kindly, guide me in this regard. Thanks.

Re: control break statement

Former Member — Tue, 10 Oct 2006 13:52:21 GMT

hi,

Use READ table statement after that ..

        AT NEW.
          READ TABLE it_combined INDEX v_tabix.
          WRITE : IT_COMBINED-FIELD1.
        ENDAT.

REgards,

Santosh

Message was edited by: Santosh Kumar P

Re: control break statement

Former Member — Tue, 10 Oct 2006 13:52:54 GMT

Hi Cartesian,

Whenever you use Control Breaks at a field,

all the fields after that gets *.

So before using Control Break stmt, pass the data into another work area of same type and use for printing.

Reward point if it helps.

Manish

Re: control break statement

RichHeilman — Tue, 10 Oct 2006 13:53:55 GMT

Simply move the data to a work area and write the data that is in the workarea instead.

data: begin of itab occurs 0,
      fld1 type c,
      fld2 type c,
      fld3 type c,
      end of itab.
data: wa like line of itab.

loop at itab.

wa = itab.

at new fld1.

   write:/ wa-fld1, wa-fld2, wa_fld3.
endat.

endloop.

Regards,

RIch Heilman

Re: control break statement

Former Member — Tue, 10 Oct 2006 13:54:29 GMT

Please note that when an AT event is fired (i.e. AT NEW, AT FIRST, AT END OF ) etc..the columns to the right of the defined field are all asteriked out hence if you try and display the value of that field it would be asterik.

Example.

Itab Structure

matnr

werks

lgort

qty

loop at itab.

at new werks.

=>here the value of lgort and qty would be *

endat.

endloop.

If you want to read the value...you can do the below.

loop at itab.

fs_tab = itab.

at new werks.

=> here you can use fs_tab values

endat.

Re: control break statement

anversha_s — Tue, 10 Oct 2006 13:56:19 GMT

hi,

assaign it to a work area before control brk statemnt.

loop at itab.

wa =itab.

at new ..

write wa-...

endloop.

rgds

anver

pls mark all hlpful answers

Re: control break statement

Former Member — Tue, 10 Oct 2006 13:56:36 GMT

Hi,

after at NEW

read table itab index sy-tabix.

and then use write statements...

Regards

vijay

Re: control break statement

Former Member — Tue, 10 Oct 2006 14:49:38 GMT

thanks for the reply. It solved my problem.

Re: control break statement

RichHeilman — Tue, 10 Oct 2006 15:02:02 GMT

<i>hi,

assaign it to a work area before control brk statemnt.

loop at itab.

wa =itab.

at new ..

write wa-...

endloop.

rgds

anver</i>

Yep, and that is exactly what I said...

Regards,

Rich Heilman