topic Re: code error in Application Development and Automation Discussions

code error

Former Member — Mon, 07 Aug 2006 15:44:16 GMT

friends, hope u r well and doing good at yr places.

this is jain as bw consultant not having much knowledge of abap progrtamming. could you please suggest me , i am getting a error from following prog.

Report Ztest.

data: ztest1 type standard table of pa0001

inital size 0.

data: ztest type pa0001.

Select * into corresponding fields of ztest1

from pa0001.

loop at ztest1 into ztest.

write:/ ztest.

endloop.

The error is - .you can not use ther syntax write

7uline ztest.

please advice me.

Re: code error

RichHeilman — Mon, 07 Aug 2006 15:45:35 GMT

Here is the corrected code.



data: ztest1 type standard table of pa0001.
data: ztest type pa0001.

select * into corresponding fields of table ztest1
from pa0001.

  loop at ztest1 into ztest.
    write:/ ztest.
  endloop.

Regards,

Rich Heilman

Re: code error

Former Member — Mon, 07 Aug 2006 15:48:35 GMT

data: ztest1 type standard table of pa0001.

data: ztest type pa0001.

Select * into corresponding fields of table ztest1

from pa0001.

loop at ztest1 into ztest.

write:/ ztest-pernr.

*--here you write all the fields separately, instead of just ZTEST.

endloop.

Message was edited by: Srikanth Kidambi

Re: code error

Former Member — Mon, 07 Aug 2006 15:49:27 GMT

hi jain,

data: ztest1 type standard table of pa0001 initial size 0.

data: ztest type pa0001.

Select * into corresponding fields of table ztest1

from pa0001.

loop at ztest1 into ztest.

write:/ ztest-pernr.

endloop.

Re: code error

Former Member — Mon, 07 Aug 2006 15:50:32 GMT

There are two mistakes

1. You need to use table keyword

2. A space is needed in write statement.

- Sanjay

Re: code error

Former Member — Mon, 07 Aug 2006 15:51:46 GMT

Akshay,

You need to write each individual field of ZTEST.

ex.. write : / ztest-a, ztest-b.

Regards

Anurag

Re: code error

Former Member — Mon, 07 Aug 2006 15:52:37 GMT

Hi,

data: ztest1 type standard table of pa0001

inital size 0 with header line.

Select * into corresponding fields of table ztest1

from pa0001.

loop at ztest1.

write:/ ztest1-pernr.

endloop.

regards,

keerthi.

Re: code error

Former Member — Mon, 07 Aug 2006 16:02:19 GMT

you need to include keyword 'table'.

otherwise it will consider ztest1 as workarea.

check the following code.

data: ztest1 type standard table of pa0001 INITIAL SIZE 0.

data: ztest type pa0001.

Select * into corresponding fields of TABLE ztest1 from pa0001.

loop at ztest1 into ztest.

write:/ ztest.

ENDLOOP.

Reward points if helpful.

Regards,

Swathi.