topic Re: generated IDoc type cannot be changed in Application Development and Automation Discussions

generated IDoc type cannot be changed

Former Member — Thu, 07 Sep 2006 04:27:06 GMT

Hi gurus,

ZIDoc type cannot be changed in WE30 as it gives message that it is generated. Any suggestion where it can be changed or from where it is generated so I can change it there. Thanks.

Regards,

Faiq

Re: generated IDoc type cannot be changed

Former Member — Thu, 07 Sep 2006 04:32:16 GMT

you can got WE31 EDIT->cancel release and then again make the changes and generate the idoc type.

Re: generated IDoc type cannot be changed

Former Member — Thu, 07 Sep 2006 06:02:46 GMT

Hi,

I am using "Zidoc_type" and then segments I am using in it are sap standard segments. currently the segment properties are Min = 1 and Max = 1 (when we double click a segment in WE30). The requirement is to change the property Max = 5, so I can send multiple segments. But it is not letting me change as says that IDoc type is generated and I am not sure that from where this ZIDoc_type is generated. Please advice. Thanks.

Regards,

Faiq

Re: generated IDoc type cannot be changed

Former Member — Thu, 07 Sep 2006 07:37:57 GMT

Hi Faiq,

Goto WE30, give the IDoc type.

Goto EDIT in menu, then EDIT -> Cancel release...

After that you do the changes.

hope this helps!

best regards,

Thangesh

Re: generated IDoc type cannot be changed

Former Member — Thu, 07 Sep 2006 07:43:42 GMT

Hi there,

I did edit -> cancel release, but it says it is not released and if I do change mode it says it is a generated one so only display possible. Any suggestion would be appreciated !

Regards,

Re: generated IDoc type cannot be changed

Former Member — Fri, 08 Sep 2006 05:32:00 GMT

Hi there,

Well I tried edit -> cancel release and change the IDoc type (TCode WE30) in R/3 and it works fine and lets me change. But in CRM environment it still gives the error that it is generated and does not go in change mode. Looking forward to your reply.

Regards,

Faiq