topic Re: read 'last change' data & time from application server in Application Development and Automation Discussions

read 'last change' data & time from application server

Former Member — Mon, 17 Jul 2006 08:44:39 GMT

Hi all,

I'm looking for a way to read the following information from the application server

Last change Creator Name

17.07.2006 09:19:58 cbdadm file1.csv

27.05.2003 10:53:11 cbdadm file2.csv

13.07.2006 17:01:30 cbdadm file3.csv

I want to see for a number of filenames, when it was last changed, but I don't know where to get this data? Is it stored in a table? And how should I read this data?

I see that a program named RSWATCH0 is generating the required output for transaction AL11...maybe this is helpful?

thanks in advance! points will be rewarded for usefull answers

Re: read 'last change' data & time from application server

andreas_mann3 — Mon, 17 Jul 2006 08:54:05 GMT

hi,

have a look to this link:

Andreas

Re: read 'last change' data & time from application server

Former Member — Mon, 17 Jul 2006 09:15:12 GMT

Hello Joris,

please check the below system function.

You have to call system function like this..

you can refer to the program RSWATCH0

CALL 'C_DIR_READ_NEXT'

ID 'TYPE' FIELD file-type

ID 'NAME' FIELD file-name

ID 'LEN' FIELD file-len

ID 'OWNER' FIELD file-owner

ID 'MTIME' FIELD file-mtime

ID 'MODE' FIELD file-mode

ID 'ERRNO' FIELD file-errno

ID 'ERRMSG' FIELD file-errmsg.

Reward if helps.

Thanks,

Krishnakumar

Message was edited by: Krishnakumar

Re: read 'last change' data & time from application server

Former Member — Mon, 17 Jul 2006 09:29:33 GMT

Hi,

Run this Program it will show the list of fiels with last changed date and time.

REPORT  ZTESTTTT.

data: begin of tabl occurs 500,
        line(400),
      end of tabl.
data: unixcom like   rlgrap-filename.
data: lines type i.
unixcom = 'ls -al'.
refresh tabl.

  call 'SYSTEM' id 'COMMAND' field unixcom
                id 'TAB'     field tabl[].

  describe table tabl lines lines.
  loop at tabl.
    write:/01 tabl-line.
  endloop.
  skip 2.
  if lines = 0.
    write:/ 'NO Occurances were found'.
  endif.

Regards

vijay

Re: read 'last change' data & time from application server

Former Member — Mon, 17 Jul 2006 09:40:24 GMT

thanks a lot guys,

the link from andreas allowed me to adjust the program to list all information necessary.

I moved this topic to BSP programming, because now, I must enable this abap in BSP.

points have been rewarded. Topic closed!