Passing two paramaters from sapscript to calling program

Former Member — Wed, 28 Jun 2006 08:51:50 GMT

Hi all,

Apparently, I wish to pass 2 parameters from sapscript to called program, and trigger the subroutine from the program to manipulate some data. Below is my coding in my sapscript:

PERFORM GET_PO_MAT_TEXT IN PROGRAM ZMMSCC_PO_OUTPUT

USING &EKPO-EBELN& &EKPO-EBELP&

CHANGING &PO_MAT_TXT&

ENDPERFORM

<u>Called Program:</u>

READ TABLE in_param WITH KEY 'EKPO-EBELN'.

IF sy-subrc = 0.

lebeln = in_param-value.

endif.

READ TABLE in_param WITH KEY 'EKPO-EBELP'.

IF sy-subrc = 0.

lebelp = in_param-value.

endif.

Based on the coding above, the program reads incoming parameters with key EKKO-EBELN and EKKO-EBELP, however, I just can grab the value from parameter EKKO-EBELN only, not both of value from EKKO-EBELN and EKKO-EBELP.

Can somebody guide me on how to pass two parameters from a sapscript to a subroutine program?

Any advise will be much appreciated.

Thanks.

Patrick

Re: Passing two paramaters from sapscript to calling program

Former Member — Wed, 28 Jun 2006 08:55:48 GMT

Hi Patrick

You have to add the USING statement before each parameter:

PERFORM .....

USING &EKKO-EBELN&

USING &EKKO-EBELP&

CHANIGN ...

Regards,

John.

topic Passing two paramaters from sapscript to calling program in Application Development and Automation Discussions

Passing two paramaters from sapscript to calling program

Re: Passing two paramaters from sapscript to calling program