topic Re: Editing a Table entry while debugging in Application Development and Automation Discussions

Editing a Table entry while debugging

Former Member — Mon, 24 Jul 2006 07:39:51 GMT

Dear All how can I edit a table entry in SE11 during debugging mode ?

Regards,

Alok.

Re: Editing a Table entry while debugging

Former Member — Mon, 24 Jul 2006 07:42:55 GMT

Hello,

Put /h.

Change the Code = EDIT and press F8.

If useful reward.

Vasanth

Re: Editing a Table entry while debugging

Former Member — Mon, 24 Jul 2006 07:46:49 GMT

Goto SE11 ,

goto the screen where the entries are displayed

select one record by using the checkbox

then press /h in the input textbox at left top of page and then enter

now change the SY-UCOMM to EDIT and u can change that entry of that record

Re: Editing a Table entry while debugging

Former Member — Mon, 24 Jul 2006 07:49:42 GMT

Follow the procedure.

Step 1.

Open the detail of the record that you have to edit in SE11.

Step 2.

Start debugging by putting /h.Press 'Enter' two times.

Step 3.

change the value of code from 'SHOW' to 'EDIT'.Execute.Now you can change the record.Save it.

One restriction : You cannot change the key field by this method.

Message was edited by: mukesh kumar

Re: Editing a Table entry while debugging

Former Member — Mon, 24 Jul 2006 07:52:21 GMT

Hi,

Just do a '/h' press F5 change the code = EDIT by clicking on the pushbutton for change and then press F8.

Hope this helps u.

Reagards,

Seema.

Re: Editing a Table entry while debugging

Former Member — Mon, 24 Jul 2006 07:53:36 GMT

Do /h for debugging mode.

When u r in debugging mode which entry u want to edit

Press edit & put the value.Now ur program run according to ur value.

Regards

Abhishek

Re: Editing a Table entry while debugging

tholuganti — Fri, 07 Aug 2015 20:35:13 GMT

This message was moderated.

Re: Editing a Table entry while debugging

former_member184158 — Fri, 07 Aug 2015 23:00:39 GMT

Hi,

you can enter the table name and select one record .

enter /h in Command code,

then the command will be SHOW, so you have to change it to EDIT; and you can edit the record & save it.

Regards

Ibr