topic Re: PM Measuring points Update BAPI or FM in Application Development and Automation Discussions

PM Measuring points Update BAPI or FM

Former Member — Fri, 30 Jun 2006 14:37:03 GMT

Hi All.

I have to write a program that has to update the

target, lower range and upper range of an equipment's

measuring points.

I have all the data in a flat file (except the measuring points which have to be calculated internally).

Does anybody know of a BAPI or a FM to accomplish this?

Help will be greatly appreciated.

Re: PM Measuring points Update BAPI or FM

sridhar_k1 — Fri, 30 Jun 2006 16:21:49 GMT

I think there's no bapi to update measuring points, write a program to upload data using transaction IK02.

You can get the measuring points from table IMPTT, using EQUI-OBJNR.

Regards

Sridhar

Re: PM Measuring points Update BAPI or FM

Former Member — Fri, 30 Jun 2006 16:33:19 GMT

Try this fm: MEASUREM_POINT_RFC_SINGLE_002

Regards,

Ravi

Re: PM Measuring points Update BAPI or FM

Former Member — Fri, 30 Jun 2006 16:35:35 GMT

Hi Ryno,

Have you looked FM TABLE_IMPTT_UPDATE?

Regards,

Ferry Lianto

Re: PM Measuring points Update BAPI or FM

Former Member — Mon, 13 Oct 2008 13:31:43 GMT

I have created a Measurement Document based on a Measuring Point(Using RFC 'MEASUREM_DOCUM_RFC_SINGLE_001')

When I take a look at the list of Measurement Documents, the Order number is always blank.

Is there somewhere Or any RFC/Logic so as to update the new measurement document with an order?

That will really help. Thanks so much.

Re: PM Measuring points Update BAPI or FM

guillaume-hrc — Mon, 11 May 2020 16:36:30 GMT

This FM is just wrapping a DB update on IMPTT, it's a start.
You might also want to create change pointers and you may want to have a look a FM 'IMPT_WRITE_DOCUMENT'