topic Re: activating single component in User-exits in Application Development and Automation Discussions

activating single component in User-exits

Former Member — Thu, 06 Jul 2006 09:30:03 GMT

hi guys

when activating my project which includes 1 component & 2 function exits here all r activated but i want my required function exit 2 be activated

can any one tell me the procedure

thanks & regards

Anil kumar Palakala

Re: activating single component in User-exits

Former Member — Thu, 06 Jul 2006 09:34:36 GMT

You can remove those from the project and reactivate the project.

Regards,

Ravi

Re: activating single component in User-exits

Former Member — Thu, 06 Jul 2006 10:23:16 GMT

Hi Anil,

Check how many Functions are implemented. If your Function exit is not implemented there is no effect even though it is active. So implement your Function exit then activate the project.

Hope this info is helpful.

Thanks & regards,

Lijo Joseph

Re: activating single component in User-exits

Former Member — Thu, 06 Jul 2006 10:40:19 GMT

Hi anil,

Though there are components in the Project,That will not cause any effect, since you are not using them or implementing them, so implement and activate only your fucntion exit2. or else exclude them from the Project.

Regards

vijay

Re: activating single component in User-exits

Former Member — Thu, 06 Jul 2006 10:44:17 GMT

Hi anilkumar,

1. If all are activated, thats ok, not a problem.

2. go in CMOD,

type your project name.

3. Then see COMPONENTS

4. In the output,

there will be 2nd column

IMPL = IMPLEMENTED

5. U will see that

there will be GREEN TICK

along side the FM, which u have code.

6. For rest, it will be BLANK.

regards,

amit m.