topic Re: Vertically Scrolling in TableControll on Subscreen leaves Programm in Application Development and Automation Discussions

Vertically Scrolling in TableControll on Subscreen leaves Programm

jkallidat_innoface — Thu, 12 Mar 2020 13:35:28 GMT

Following Problem:

I have a TC on a CustomSubscreen embedded in mm01/2/3 Basic Data 2..

When I scroll vertically using scrollbar or "mouse wheel" it wants to leave the Programm with the Information Pop-Up:

"Last data screen reached"

I don't understand why!
I already defined the screennumber as the following Screen

Any Ideas?

Re: Vertically Scrolling in TableControll on Subscreen leaves Programm

michael_piesche — Thu, 12 Mar 2020 14:02:13 GMT

Have you tried activating the debug mode with "/h" just before scrolling and see to where it leads you? Normally it shouldnt jump in the debug mode with just scrolling, but obviously an event gets activated in your case, so you must end up in coding that will return to the previous screen.

Re: Vertically Scrolling in TableControll on Subscreen leaves Programm

jkallidat_innoface — Thu, 12 Mar 2020 14:40:16 GMT

I just noticed the popup says "Last data screen reached"...

Re: Vertically Scrolling in TableControll on Subscreen leaves Programm

Sandra_Rossi — Thu, 12 Mar 2020 14:58:03 GMT

michael.piesche If it's a "Table Control", the scrolling should call the PAI.

Re: Vertically Scrolling in TableControll on Subscreen leaves Programm

jkallidat_innoface — Thu, 12 Mar 2020 15:03:44 GMT

It starts in HOOK_DYNP_RAL_PAI and then runs through the PAI of all Subscreens

Re: Vertically Scrolling in TableControll on Subscreen leaves Programm

Sandra_Rossi — Thu, 12 Mar 2020 18:40:31 GMT

As Michael said, debug your program (not the system programs like HOOK_DYNP_RAL_PAI), we can't do that for you.