topic SCI AUTOMATION in Application Development and Automation Discussions

SCI AUTOMATION

Former Member — Thu, 02 Jan 2020 12:39:12 GMT

I am getting error 'there is no inspection' while executing fm 'SCI_GET_INSPECTION_PLAIN_LIST'

to get result as plain list directly.

Re: SCI AUTOMATION

RobertVit — Thu, 02 Jan 2020 13:53:26 GMT

Please be more specific and check community rules

Re: SCI AUTOMATION

NTeunckens — Thu, 02 Jan 2020 21:11:33 GMT

Please go through basic Debugging and see why this Message is Raised when executing the Function Module ...

I believe the Message is "SCI 050" and it is probably raised on one of the very first Steps withing the Logic of the FM ...

Re: SCI AUTOMATION

cdprasanna — Fri, 03 Jan 2020 04:17:17 GMT

hi,

Run FM in debugging mode and set break point at statement and then F8 which will stop the cursor at the place where error message has been raised then you analyse the cause of the error.

you can set break point by following below path.

breakpoints->breakpoint at->breakpoint at statement->type 'message' under ABAP Cmnds column.

Thanks.