topic Re: run time error CALL_FUNCTION_PARM_MISSING in Application Development and Automation Discussions

run time error CALL_FUNCTION_PARM_MISSING

former_member607877 — Wed, 05 Jun 2019 05:19:38 GMT

The current ABAP program "SAPLBFFM" had to be terminated because it has come across a statement that unfortunately cannot be executed.

An exception occurred that is explained in detail below. The exception, which is assigned to class 'CX_SY_DYN_CALL_PARAM_MISSING', was not caught in procedure "OPEN_FI_PERFORM_00001040_E" "(FUNCTION)", nor was it propagated by a RAISING clause. Since the caller of the procedure could not have anticipated that the exception would occur, the current program is terminated. The reason for the exception is: When calling the function module "ZSAMPLE_PROCESS_00001040", one of the parameters needed according to the interface description was not specified. This parameter was "I_F150D2".

Re: run time error CALL_FUNCTION_PARM_MISSING

RobertVit — Wed, 05 Jun 2019 06:16:22 GMT

Your question is simply the DUMP - which in this (most) case(s) already has the solution...

Re: run time error CALL_FUNCTION_PARM_MISSING

matt — Wed, 05 Jun 2019 06:30:47 GMT

Just wondering. Which part of

When calling the function module "ZSAMPLE_PROCESS_00001040", one of the parameters needed according to the interface description was not specified. This parameter was "I_F150D2".

don't you understand?

Re: run time error CALL_FUNCTION_PARM_MISSING

Sandra_Rossi — Wed, 05 Jun 2019 07:01:16 GMT

What is the question?

Re: run time error CALL_FUNCTION_PARM_MISSING

former_member607877 — Wed, 05 Jun 2019 10:02:53 GMT

Dear Matthew,

Where to maintain the parameter? i dont understand.

Re: run time error CALL_FUNCTION_PARM_MISSING

Sandra_Rossi — Wed, 05 Jun 2019 11:11:12 GMT

To cross the Ts, in the function module "OPEN_FI_PERFORM_00001040_E", there's a line "CALL FUNCTION FMTAB-FUNCT" (at run time it corresponds to calling the function module "ZSAMPLE_PROCESS_00001040") with the parameter "I_F150D2". So ZSAMPLE_PROCESS_00001040 should also contain the parameter "I_F150D2", right?

What don't you understand?

Ask any developer at your company if you require assistance.

PS: this parameter seems to not be part of the standard.