Smartform Error-Incorrect memory access has been detected

Former Member — Wed, 22 Jun 2016 07:08:13 GMT

Hello experts,

I have tried to display the employee photo on the smartform dynamically based on the pernr. Its working fine. But immediately after displaying the smartform, the SAP is getting logged off.

I tried searching for the solutions, but didn't find any. Please help me out.

Regards,

Siraj.

Re: Smartform Error-Incorrect memory access has been detected

pranay570708 — Wed, 22 Jun 2016 08:00:12 GMT

Hi,

First, ensure you are using the latest SAPGUI release and patch version. Test if the problem still occurs with the latest SAPGUI:
- 1053737 - Expected release dates for SAP GUI for Windows & ITS Patches
- 563161 - SAP GUI, SAP ITS & SAP IGS patches on Service Marketplace
For older releases and SP levels on 640 and below, check the note 766874:
- 766874 - OTF-Preview: Error message "Incorrect memory access"
If steps 1 and 2 above do not help, then the issue is likely caused by a problem or corruption with the graphic used in the spool. You should delete this graphic from SE78. Upload a new correct graphic into SE78 if it is required.

Follow below doc:

SAPGUI Crash When Displaying Spool With Graphic - ABAP Development - SCN Wiki

topic Re: Smartform Error-Incorrect memory access has been detected in Application Development and Automation Discussions

Smartform Error-Incorrect memory access has been detected

Re: Smartform Error-Incorrect memory access has been detected